We are repair and servicing Firing Cards (DMD-99). Service includes detailed fault inspection, replacement of damaged firing components, and testing under operational conditions. If you want to repair such cards, we can provide the service. We are not the manufacturer – we only provide repair services.

We repair Single Axis Tracker – HPU Controllers with issues such as tracking malfunction, hydraulic pressure instability, overheating, and control failure. Testing identified faults in control circuits, sensors, hydraulic valve actuation, power supply sections, and internal connections, which affected reliable tracker operation. Our engineers carried out micro-level repairs and component-level rectification. After thorough functional and load testing, the HPU controller operated correctly and reliably. The unit is now suitable for industrial and solar plant use.

Note: We are not manufacturers; we only provide repair services.

We repair S71202 CAN EtherCAT 3-Phase Drives with communication failure and drive faults. Testing showed control PCB issues, power section faults, and communication errors. These caused unstable drive operation. Micro-level repairs and replacements were carried out. After testing, the drive was suitable for industrial use.
Note: We are not manufacturers; we only repair.

We repair Stepping Motor Drive X-Mind B6 that showed faults in signal response and motor synchronization. Our engineers detected defective ICs, damaged capacitors, and regulator issues during testing. These faults disturbed precise motor control. After component replacement and circuit correction, the drive was tested under company-level standards. It then worked smoothly and reliably for industrial applications.
Note: We are not manufacturers, we only repair.

We repair Selec MFM384 Multifunction Meter which showed incorrect readings and frequent display errors. Testing revealed IC faults, capacitor damage, and power circuit issues. These prevented proper monitoring. We repaired the circuits and replaced the faulty parts. After testing, the meter worked reliably with stable performance. The repaired unit was ready for continued use.
Note: We are not manufacturers, we only repair.

We are repair and servicing SENECA Z-4TC-D Temperature Modules with professional expertise. Our engineers analyze the module with advanced tools to trace failures at the circuit and component stage. After detection, defective parts are carefully replaced and verified through functional testing. The repaired module undergoes load and stability checks to confirm reliable operation. If you want to repair such modules, we can provide the service. We are not the manufacturer – we only provide repair services.

We are doing repair of SMC-5900 Module, which had malfunctioning circuits and unstable operations. Our engineers analyzed the module and found issues in processor ICs, capacitors, and regulators. After corrective repairs, the module achieved consistent functionality for industrial use. If you want repair of this type of module, contact us. Please note, we are not manufacturers — we are doing only repair.

We repaired an SSB WIND Systems BFL170 Relay that was showing malfunction in switching operations. Our team conducted precise testing, identified faulty relay contacts and driver components, and replaced them with quality parts. After repair, the relay performed reliably under continuous load. Please note, we are not manufacturers — we provide repair services only.

We repair POWER SNC010-PS1 Card that failed in voltage regulation and circuit operation. Testing revealed IC faults, regulator failures, and capacitor issues. Our engineers repaired the circuits and replaced defective components. After repair, the card worked with reliable performance.
Note: We are not manufacturers, we only repair.

We repair Sartorius Stedim Sartocheck 3 Plus that showed power issues and sensor errors. Testing highlighted IC failures, regulator faults, and capacitor problems. These faults disturbed proper operation. Our engineers carried out circuit-level repairs and replaced defective components. After repair, the machine was tested under company standards. It then worked with stable and smooth functionality.
Note: We are not manufacturers, we only repair.